Creating A Traffic Isolation Zone; Adding Members To A Traffic Isolation Zone - Brocade Communications Systems WFT-2D User Manual

21
Traffic Isolation zones
8. Click OK or Apply to save your changes.

Creating a Traffic Isolation zone

Traffic Isolation zones are configurable only on a Fabric OS device. The seed switch must be
running Fabric OS 6.1.1 or later.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
4. Select Domain, Port Index from the Type list.
5. Select New TI Zone from the New Zone list.
6. Enter a name for the zone.
7.
8. Click OK or Apply to save your changes.

Adding members to a Traffic Isolation zone

NOTE
Traffic Isolation zones are configurable only on a Fabric OS device.
Use this procedure to add a member to a zone when the member is listed in the Potential Members
list of the Zone DB tab. Only ports can be added as members to a Traffic Isolation zone. You must
add two or more N_Ports as well as all E_Ports on the path between the N_Ports.
NOTE
You cannot add a device as a member to a Traffic Isolation zone.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
918
The Traffic Isolation zones are saved, but are not activated. The Traffic Isolation zones are
activated when you activate a zone configuration in the same zone database.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
For zone name requirements and limitations, refer to
page 888.
Press Enter.
The Traffic Isolation zone is saved, but is not activated.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
"Zoning naming conventions"
Brocade Network Advisor SAN User Manual
on
53-1003154-01