Setting Disk Lun Re-Key All - Brocade Communications Systems WFT-2D User Manual

Setting disk LUN Re-key All

To rekey all disk LUNs on an encryption node, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select the switch on which to perform a manual re-key from the Encryption Center Devices
FIGURE 404
3. Click Yes to includes mirror LUNs, or click No to exclude mirror LUNs.
4. Click Yes.
5. Open the Encryption Target Disk LUNs dialog box to see LUNs being rekeyed and LUNs
6. Select a disk LUN device from the table, then click LUNs.
Brocade Network Advisor SAN User Manual
53-1003154-01
dialog box. (Refer to Figure 266
table, then select Switch > Re-Key All from the menu task bar. (Refer to
Selecting the Re-Key All operation
If REPL support is enabled on the encryption group, a confirmation dialog box displays, asking
whether to rekey mirror LUNs.
A warning message displays, requesting confirmation to proceed with the rekey operation.
Rekeying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the
switch, the remaining rekey operations are held in the pending state.
pending.
a. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 266
b. Select the encryption switch from the Encryption Center Devices table, then select Targets
from the menu task bar.
The Encryption Targets dialog box displays. (Refer to
The Encryption Targets Disk LUNs dialog box displays. (Refer to
lists the status of the rekey operation.
Rekeying all disk LUNs manually
on page 694.)
on page 694.)
Figure
20
Figure 404.)
376.)
Figure 405.) The dialog box
857