In A Container - Brocade Communications Systems WFT-2D User Manual

20
Tape LUN statistics
4. Select the LUN or LUNs for which to display or clear statistics, then click Statistics.
FIGURE 392
5. Do either of the following:
Viewing and clearing statistics for tape LUNs in a container
To view or clear statistics for tape LUNs in a container, follow these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a group, switch, or engine from the Encryption Center Devices table that contains the
838
The Tape LUN Statistics dialog box displays. (Refer to
on the LUN or LUNs you selected is displayed. Tape LUN statistics are cumulative.
Tape LUN Statistics dialog box
The dialog box contains the following information:
•
LUN #: The number of the logical unit for which statics are displayed.
•
Tape Volume/Pool: The tape volume label of the currently-mounted tape, if a tape session
is currently in progress.
•
Tape Session #: The number of the ongoing tape session.
•
Uncompressed blocks: The number of uncompressed blocks written to tape.
•
Compressed blocks: The number of compressed blocks written to tape.
•
Uncompressed Bytes: The number of uncompressed bytes written to tape.
•
Compressed Bytes: The number of compressed bytes written to tape.
•
Host Port WWN: The WWN of the host port that is being used for the write operation.
•
A Refresh button updates the statistics on the display since the last reset.
•
A Clear button resets all statistics in the display.
a. Click Clear to clear the tape LUN statistics, then click Yes to confirm.
b. Click Refresh to view the current statistics cumulative since the last reset.
dialog box. (Refer to Figure 266
storage device to be configured, then select Group/Switch/Engine > Targets from the menu
task bar.
Figure
on page 694.)
Brocade Network Advisor SAN User Manual
392.) The statistic results based
53-1003154-01