Brocade Communications Systems WFT-2D User Manual page 1261

Configuring Static Flow template
The Static Flow predefined template receives the source device details from the storage array,
searches all the zones where the source device is a member, iterates through all the zone
members and receives each initiator or initiator with target port details, and creates flow definition
row using the device port and source port details as shown in
FIGURE 520
Perfom the following steps, in the Add Flow Definition - Static Flow dialog box:
The default Device View is Port Address.
1. The Flow Name field is filled with the predefined flow name and the format is
2. Select one of the following format options for Device View list:
3. Click Show Details to view information about the Target Switch, Ingress, and Egress ports
4. Click OK to deploy the flow definition.
Brocade Network Advisor SAN User Manual
53-1003154-01
Add Flow Definition - Static Flow template dialog box
<portname>_<last 4 digits of the source device WWN>_<last 4 digits of the destination device
WWN>.
•
Port Address (port ID) — Select to display the source and destination device address using
the port ID. The default Device View is Port Address.
•
WWN (world wide name) — Select to display the source and destination device address
using the port WWN.
based on the selected device details.
This data is not editable. Click Hide Details to hide the Target Switch, Ingress, and Egress port
information.
The Deployment Status dialog box displays with a list of all defined flows in the Flow Definitions
Status table, as shown is
Definitions Status table.
Predefined flow definition templates
Figure 518. Refer to Table 13
Figure 519.
for the data displayed in the Flow
29
1209