Trap Customization - Brocade Communications Systems WFT-2D User Manual

32
SNMP traps

Trap customization

The Trap Configuration tab of the Event Reception dialog box enables you to configure the following
settings:
•
•
Registering traps
Traps must be registered in the Event Reception dialog box to make them available.
To register traps, complete the following steps.
1. Select Monitor > SNMP Setup > Event Reception.
2. Click the Trap Configuration tab.
3. Expand a folder for a MIB to display the traps in the MIB. If the list is too long, use the Search
1272
Register and unregister various Management Information Bases (MIBs)
Customize trap description messages based on varbinds and severity and specify alias names
The Trap Configuration tab of the Event Reception dialog box, shown in
The Registered and Not Registered buttons at the top of the Traps tree serves as a filter for the
traps. If there are unregistered traps, they are listed when you select the Not Registered
button.
Traps appear under each MIB folder. The MIB folders correspond to the MIBs identified in the
mibs_to_compile.txt file.
FIGURE 545
Trap Configuration tab of the Event Reception dialog box
tool to find a MIB or trap.
Figure 545, displays.
Brocade Network Advisor SAN User Manual
53-1003154-01