Importing A Signed Kac Certificate Into A Switch - Brocade Communications Systems WFT-2D User Manual

20
Steps for connecting to a KMIP-compliant SafeNet KeySecure

Importing a signed KAC certificate into a switch

After a KAC CSR has been submitted and signed by a CA, the signed certificate must be imported
into the switch.
NOTE
This operation can be performed only after the switch is added to the encryption group.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select a switch from the Encryption Center Devices table, then select Switch > Import
FIGURE 304
3. Browse to the location where the signed certificate is stored, then click OK.
756
dialog box. (Refer to Figure 266
Certificate from the menu task bar.
The Import Signed Certificate dialog box displays. (Refer to
Import Signed Certificate dialog box
The signed certificate is stored on the switch.
on page 694.)
Brocade Network Advisor SAN User Manual
Figure 304.)
53-1003154-01