Limitations Of Bottleneck Detection - Brocade Communications Systems WFT-2D User Manual

28
Bottleneck detection
NOTE
A bottleneck cleared alert is sent if you disable bottleneck detection on a bottlenecked port, even
though the port is still bottlenecked.
Bottlenecks can be highlighted in the Connectivity Map and Product List. Select Monitor >
Performance > View Bottlenecks. If a port is experiencing a bottleneck, a bottleneck icon is
displayed in the Connectivity Map for the switch and fabric, and in the Product List for the port,
switch, and fabric, as shown in
FIGURE 482

Limitations of bottleneck detection

The bottleneck detection feature for latency detection is not recommended for link utilizations
above 85 percent.
The bottleneck detection feature detects latency bottlenecks only at the point of egress, not
ingress. For example, for E_Ports, only the traffic egressing the port is monitored. For FCoE ports,
bottleneck detection monitors traffic going from the FC side to the DCB side, and does not monitor
traffic going in the reverse direction.
Enabling bottleneck alerts and configuring alert parameters
Bottleneck detection is enabled on a switch or fabric basis. It enables both latency and congestion
detection. Consider these points when enabling bottleneck detection:
•
•
•
•
If ineligible ports later become eligible or, in the case of a logical switch, if ports are moved to the
logical switch, bottleneck detection is automatically applied to those ports.
If you add additional switches, including logical switches, to the fabric, bottleneck detection is not
automatically applied, so be sure to enable bottleneck detection on those switches as well.
NOTE
It is recommended that you enable bottleneck detection on every switch in the fabric.
1102
Bottleneck port indications
If you enable bottleneck detection on a fabric, the feature is applied to all eligible switches in
the fabric and all eligible ports on the switches.
If you enable bottleneck detection on a switch, the feature is applied to all eligible ports on that
switch.
You can override switch configuration by changing parameters for specific ports.
When changing switch-level parameters, such as time and severity threshold values,
bottleneck detection will be disabled, then enabled.
Figure 482. In the figure, port15 and port22 are bottlenecked.
Brocade Network Advisor SAN User Manual
53-1003154-01