3. Enter a name for the flow in the Name field.
4. Select the Monitor check box.
5. Select one of the following options to define the flow direction:
6. If you want to persist this flow definition over reboots, select the Persist over switch reboots
7.
8. Change target switch for the flow definition by clicking the ellipsis button to the right of the
Brocade Network Advisor SAN User Manual
53-1003154-01
FIGURE 497
Add Flow Definition dialog box
The name cannot be over 20 characters and can only include alphanumeric characters or
underscores.
NOTE
For a physical switch, the name must be unique. However, for logical switches, the name does
not have to be unique.
•
Source to Destination — Select to define the flow direction from an ingress port to an
egress port, or a source device (in traffic) to a destination device (out traffic).
•
Bidirectional — Select to define the flow direction to be monitored in both directions.
NOTE
You cannot use the LUN and Bidirectional parameters in a flow definition.
check box.
If you want to immediately activate the flow after creation, select the Activate all selected
features check box.
Target Switch field.
29
Flow Monitor
1141