Brocade Communications Systems WFT-2D User Manual page 390

7
User-defined performance monitors
9. (Time series monitors only) Add targets for the monitor by clicking Add and completing the
10. Click OK on the Add Performance Dashboard Monitor dialog box.
11. Click OK on the Customize Dashboard dialog box.
Accessing additional data from user-defined port performance monitors
•
•
•
338
(Distribution monitors only) The increasing order defaults are as follows: 0 through 20 displays
green, 21 through 40 displays blue, 41 through 60 displays yellow, 61 through 80 displays
orange, and 81 through 100 displays red.
a. (Top N and Bottom N monitors only) Select the check box.
b. Enter a number in the field.
c. Click the color square to launch the Color dialog box.
•
To pick a color from a swatch, select the Swatches tab. Select a color from the display.
•
To specify a color based on hue, saturation, and brightness, click the HSV tab. Specify
the hue (0 through 360 degrees), saturation (0 through 100%), value (0 through
100%), and transparency (0 through 100%).
•
To specify a color based on hue, saturation, and lightness, click the HSL tab. Specify
the hue (0 through 360 degrees), saturation (0 through 100%), lightness (0 through
100%), and transparency (0 through 100%).
•
To specify a color based on values of red, green, and blue, click the RGB tab. Specify
the values for red (0 through 255), green (0 through 255), blue (0 through 255), and
alpha (0 through 255).
•
To specify a color based on values of cyan, magenta, yellow, and black, click the CMYK
tab. Specify the values for cyan (0 through 255), magenta (0 through 255), yellow (0
through 255), black (0 through 255), and alpha (0 through 255).
•
To reset to the default color, click Reset.
steps in "Adding targets to a user-defined performance monitor"
Remove targets from the monitor by selecting one or more targets in the Targets list and
clicking Remove.
The Customize Dashboard dialog box displays with the new monitor in the Performance
Monitors list.
The new performance monitors display at the bottom of the dashboard.
In a Distribution monitor, double-click a percentage range to navigate to the Measure_Type
Distribution Data Details dialog box. For more information, refer to
distribution data details" on page 339 or
In a Top N or Bottom N monitor, double-click a row or right-click a row and select Show
Graph/Table to navigate to the Custom: Historical Performance Graph dialog box for the
selected measures. For more information, refer to
performance graph" on page 1081.
In a Top N or Bottom N C3 Discards TX TO and C3 Discards RX TO monitors, right-click an
FC-port row (Fabric OS device running 7.1.0 or later) and select Discarded Frames to navigate
to the Discarded Frames dialog box. For more information, refer to
from a port" on page 510.
on page 335.
"Viewing product
"Viewing port distribution data details"
"Generating and saving a historical
"Viewing discarded frames
Brocade Network Advisor SAN User Manual
on page 340.
53-1003154-01