From Properties; Importing A Signed Public Key Certificate From Properties - Brocade Communications Systems WFT-2D User Manual

Exporting the public key certificate signing request from properties
To export the certificate signing request (CSR) under Public Key Certificate Request, complete the
following steps.
1. Click Export, then browse to the location where you want to save the certificate and click Save.
2. Submit the CSR to a certificate authority (CA) for signing. CA signing requirements and

Importing a signed public key certificate from properties

To import a signed public key certificate, complete the following steps.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select an encryption engine from the Encryption Center Devices table, then select Engine >
3. Click Import.
FIGURE 410
4. Enter or browse to the file containing the signed certificate, then click OK.
Brocade Network Advisor SAN User Manual
53-1003154-01
•
Re-Balance Recommended: Indicates if LUN rebalancing is recommended for an
encryption engine that is hosting both disk and tape LUNs. Options are Yes and No.
•
System Card Status: The current status of system card information for the encryption
engine. Options are Enabled and Disabled.
Alternatively, you may also copy the CSR and paste it to a file.
procedures differ per key manager appliance.
dialog box. (Refer to Figure 266
Properties from the menu task bar, or right-click a switch or encryption engine and select
Properties.
NOTE
You can also select a an engine from the Encryption Center Devices table, then click the
Targets icon.
The Import Signed Certificate dialog box displays. (Refer to
Import Signed Certificate dialog box
The file is imported onto the switch.
Viewing and editing switch encryption properties
on page 694.)
Figure 410.)
20
867