Brocade Communications Systems WFT-2D User Manual page 1341

3. Select the Alert by E-mail check box if you want an e-mail message to be sent to an
4. Select the Run Policy Monitor check box to execute a policy monitor as an action based on a
5. Select the Launch a Script check box if you want to execute to an external script file when the
6. Select the Broadcast to Client check box, and click Configure to broadcast a message to all the
7.
8. Click the Collect support save check box to enable SupportSave on the event. The check box is
9. Click Next to display the Action Group - E-mail Settings pane of the Add Event Action dialog box
Special events handling
The following special error conditions are examples of events that are categorized as Special
Events Handling events, a separate category that appears in the Name list of the Event Actions
dialog box. All pre-selected events are SNMP traps.
•
•
•
•
Though these error conditions are automatically considered "special events handling" events, you
can add or edit any event action and mark the action as a special event for special events handling
using the Actions pane of the Edit Event Action dialog box.
Brocade Network Advisor SAN User Manual
53-1003154-01
NOTE
Auto Acknowledge is enabled only when Take actions for the selected events when they occur
is selected in the Policy step of the Event Actions Wizard. If you edit an Event Action that has
Auto Acknowledge selected and change this option in the Policy step to Time-bound or
Frequency-bound, you will be required to confirm your choice.
administrator if the policy criteria have been met.
selected event, and then select the target for the policy monitor from the list. Target options
include Event Sender and Specified in Config.
matching criteria have been met, and then enter the script in the accompanying field.
clients when the matching criteria have been met.
NOTE
The remaining parameters are not available if a non-Fabric OS product is selected as an event
sender.
The Broadcast Message dialog box displays.
a. Select a severity level from the list.
b. Type a message in the Message Content field.
c. Click OK.
The Mark as Special Events check box is unselected by default. Leave it this way if you want
the event action to be added to the Special Event Handling event action category. Refer to
"Special events handling"
unselected by default.
if you selected Alert by E-mail. If you did not select Alert by E-mail, you will advance to the
Summary pane.
Invalid T1 zone configuration event
48-blade inserted into a non-Virtual Fabric chassis
Port fencing Fabric Watch trap, when a port is fenced
Blade Processor FPGA version is incompatible with the Fabric OS firmware version
for more complete information.
Event action definitions
32
1289