Changing A Logical Switch To A Base Switch - Brocade Communications Systems WFT-2D User Manual

19
Configuring Virtual Fabrics
5. Change the FID in the Logical Fabric ID field.
6. Click OK on the Edit Properties dialog box.
7.
8. (Optional) Select the Unbind Port Addresses while moving them check box.
9. Click Start to send these changes to the affected chassis.
10. When the changes are complete, click Close.
11. If the newly created switch is not part of a discovered fabric, then you must discover the switch.

Changing a logical switch to a base switch

The Base Switch column in the Existing Logical Switches list indicates whether a logical switch is a
base switch.
1. Select Configure > Virtual Fabric > Logical Switches.
2. Right-click anywhere in the Existing Logical Switches list and select Table > Expand All.
3. Select the logical switch you want to change to a base switch.
4. Click Edit.
5. Clear the Base Fabric for Transport check box.
6. Select the Base Switch check box.
690
The logical switch displays under the new logical fabric node in the Existing Logical Switches
list.
Click OK on the Logical Switches dialog box.
The Logical Switch Change Confirmation and Status dialog box displays with a list of all
changes you made in the Logical Switches dialog box.
The Re-Enable ports after moving them and QoS disable the ports while moving them check
boxes are selected by default.
NOTE
Ports are disabled before moving from one logical switch to another.
NOTE
Most changes to logical switches will disrupt data traffic in the fabric.
The status of each change is displayed in the Status column and Status area in the dialog box.
a. Undiscover the physical chassis. Refer to
b. Rediscover the physical chassis. Refer to
When entering the IP address, use the IP address of the physical fabric.
The Logical Switches dialog box displays.
The Edit Properties dialog box displays.
This check box is applicable only to logical switches that are not base switches.
"Deleting a fabric" on page 45 for instructions.
"Discovering fabrics" on page 37 for instructions.
Brocade Network Advisor SAN User Manual
53-1003154-01