Brocade Communications Systems WFT-2D User Manual page 1097

1. Select a chassis that contains at least two of the same type of blades.
2. Select Configure > Switch > Swap Blades.
3. Select the blade you want to replace from the first Swap Blades list.
4. Select the blade with which you want to replace the first blade from the second Swap Blades
5. Select the Enable ports after swap is complete check box to enable ports on the destination
6. Click OK.
7.
Brocade Network Advisor SAN User Manual
53-1003154-01
The Swap Blades dialog box displays.
Once you select a blade, the second list automatically filters out the selected blade and any
blade types that do not match the selected blade.
list.
blade after the swap is complete.
NOTE
This operation disrupts the traffic on all ports for the selected blades.
Click Yes on the confirmation message.
Once the swap blade operation is complete, a "success" or "failure" message displays.
25
Swapping blades
1045