Brocade Communications Systems WFT-2D User Manual page 912

20
Rekeying all disk LUNs manually
FIGURE 407
860
Re-Key Sessions Status dialog box
The dialog box contains the following information:
•
LUN #: The LUN number.
•
LUN Serial #: The LUN serial number.
•
Re-Key Session #: The number assigned to the rekeying session.
•
Percent Complete: The percentage of completion of the rekeying session.
•
Re-Key State: Options are:
-
Re-Key Setup
-
LUN Prep
-
LUN Clean-up
-
Key Update
-
Read Phase
-
Write Phase
-
HA Sync Phase
•
Re-Key Role: Options are:
-
Primary/Active
-
Backup/Active
•
Block Size: The block size used on the LUN.
•
Container Name: The CryptoTarget container name.
•
Host Port WWN: The WWN of the host port that is being used for the write operation.
•
Current LBA: The Logical Block Address (LBA) of the block that is currently being written.
•
Number of Blocks: The number of blocks written.
•
Thin Provision LUN: Identifies if the new LUN is a thin provisioned LUN. Options are:
-
Yes: Thin provision support is limited to Brocade-tested storage arrays. The thin
provision LUN status will be displayed as Yes for supported storage arrays only.
-
No: Shown as No if the LUN is not a thin provisioned LUN.
-
Unknown: Shown if the LUN status cannot be determined.
-
Not Applicable: Applies to switches that are running a Fabric OS version earlier than
v7.1.0.
Brocade Network Advisor SAN User Manual
53-1003154-01