Keyauthority (Teka) - Brocade Communications Systems WFT-2D User Manual

20
Creating a new encryption group
11. Review important messages, then click Next.
FIGURE 337
12. Review post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to
Configuring key vault settings for Thales e_Security keyAuthority (TEKA)
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 764.
Figure 338
784
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration. See
results" on page 800 for more information.
The Next Steps dialog box displays. (Refer to
certificates for the encryption switch are displayed.
Next Steps dialog box
"Understanding configuration status results"
shows the key vault selection dialog box for TEKA.
"Understanding configuration status
Figure 337.) Instructions for installing public key
on page 800.
"Creating a new encryption group"
Brocade Network Advisor SAN User Manual
53-1003154-01