Interoperability Protocol - Brocade Communications Systems WFT-2D User Manual

20
Creating a new encryption group
11. Click Next.
FIGURE 350
12. Review the post-configuration instructions, which you can copy to a clipboard or print for later.
13. Click Finish to exit the Configure Switch Encryption wizard.
14. Refer to
Configuring key vault settings for Key Management Interoperability
Protocol
The following procedure assumes you have already configured the initial steps in the Configure
Switch Encryption wizard. If you have not already done so, go to
on page 764.
NOTE:
•
794
After configuration of the encryption group is completed, the Management application sends
API commands to verify the switch configuration.
The Next Steps dialog box displays. (Refer to
certificates for the encryption switch are displayed. These instructions are specific to the key
vault type.
Next Steps dialog box
"Understanding configuration status results"
With the introduction of Fabric OS 7.1.0, KMIP with SafeNet KeySecure for key management
(SSKM) native hosting LKM is supported. Before selecting KMIP as the key vault type, all nodes
in a KeySecure encryption group must be running Fabric OS 7.1.0 or later.
Figure 350.) Instructions for installing public key
on page 800.
"Creating a new encryption group"
Brocade Network Advisor SAN User Manual
53-1003154-01