Dcb Configuration - Brocade Communications Systems WFT-2D User Manual

DCB configuration

To launch the DCB Configuration dialog box, select Configure > DCB from the menu bar.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
NOTE
For FOS DCB devices, the Protocol Down Reason column, shown in
only for the external ports of embedded platforms but not for the internal ports.
FIGURE 231
Minimum DCB configuration for FCoE traffic
You must complete the following procedures to create the basic configuration of DCB for FCoE
traffic.
NOTE
This section is applicable for Fabric OS versions 6.3.0, 6.3.1, 6.3.2, 6.4.1, and 6.4.2. This section is
not applicable for Fabric OS versions 6.3.1_dcb, 6.3.1_cee, 6.4.1_fcoe, and 7.0.x.
Creating a DCB map to carry the LAN and SAN traffic
To create a DCB map to carry the LAN and SAN traffic, complete the following steps.
NOTE
This procedure is applicable for Fabric OS versions earlier than Fabric OS 7.0. For Fabric OS versions
7.0 and later, you can only edit the default DCB map.
1. Select Configure > DCB.
2. Select the switch to edit from the Products/Ports list and click Edit.
3. Click the QoS tab.
Brocade Network Advisor SAN User Manual
53-1003154-01
DCB Configuration dialog box
The DCB Configuration dialog box displays.
The Edit Switch dialog box displays.
The Edit Switch dialog box - QoS tab displays, as shown in
DCB configuration
Figure 231, displays the values
Figure 232.
16
607