Brocade Communications Systems WFT-2D User Manual page 1227

7.
8. Enter the source edge fabric ID in the Source field.
9. Enter the destination edge fabric ID in the Destination field.
10. Select OK to save the definition.
Configuring an unspecified fabric flow using an XISL E_Port
The following example creates a flow (all_e2e_src_dcx_xisl) that monitors frames passing from all
source fabrics to all destination fabrics using a specific port (ingress or egress).
1. Right-click the XISL E_Port on which you want to monitor the flow and select Fabric Vision >
2. Enter a name (all_e2e_src_dcx_xisl) for the flow definition in the Name field.
3. Select the Persist over switch reboots check box to persist this flow definition over reboots.
4. Select the Activate all selected features check box to immediately activate the flow after
5. Select the Port Address option for End Device.
6. Clear the source port ID in the Source field.
7.
8. Select the VFID option for FCR/XISL mode.
9. Enter an asterisk (*) for the edge fabric ID in the Source field.
10. Enter an asterisk (*) for the edge fabric ID in the Destination field.
Brocade Network Advisor SAN User Manual
53-1003154-01
Select the VFID option for FCR/XISL mode.
To select the source from a list, refer to
available products" on page 1147".
To select the destination from a list, refer to
available products" on page 1147".
When the flow definition activates, the Flow Vision dialog box displays with the new flow
selected (highlighted) in the Flow Definitions table. To review the sub-flow data for the selected
flow, refer to "Monitoring a Flow Monitor flow"
Flow > Add.
The Add Flow Definition dialog box displays with the following default criteria and flow
identifiers pre-populated:
•
Feature — Monitor
•
Direction — Bidirectional
•
Source Device — * (an asterisk allows you to use any port)
•
Destination Device — * (an asterisk allows you to use any port)
•
Ingress/Egress port — XISL E_Port number
The name cannot be over 20 characters and can only include alphanumerics or underscores.
NOTE
For a physical switch, the name must be unique. However, for logical switches, the name does
not have to be unique.
creation.
Clear the destination port ID in the Destination field.
"Selecting a fabric or virtual fabric ID from a list of
"Selecting a fabric or virtual fabric ID from a list of
on page 1149".
29
Flow Monitor
1175