Brocade Communications Systems WFT-2D User Manual page 822

20
Creating a new encryption group
1. Enter the IP address or host name for the primary key vault. If you are clustering DPM
2. Enter the name of the file that holds the Primary Key Vault's CA Key Certificate or browse to the
3. If you are implementing encryption on data replication LUNs used by the EMC Symmetrix
4. Click Next.
FIGURE 319
5. Enter the filename in which you want to store the certificate information, or browse to the file
6. Click Next.
770
appliances for high availability, IP load balancers are used to direct traffic to the appliances.
Use the IP address of the load balancer.
desired location. This file can be generated from the key vault's administrative console.
Remote Data Facility (SRDF), you must select Enabled for REPL Support.
The Specify Certificate Signing Request File Name dialog box displays. (Refer to
Specify Certificate Signing Request File Name dialog box
location.
The certificate stored in this file is the switch's Switch Certificate Signing file. You will need to
know this path and file name to install the switch's Switch Certificate Signing file on the key
management appliance.
The Specify Master Key File Name dialog box displays. (Refer to
Figure
Figure 320.)
Brocade Network Advisor SAN User Manual
53-1003154-01
319.)