Brocade Communications Systems WFT-2D User Manual page 1258

29
Predefined flow definition templates
FIGURE 517
3. Enter a name for the flow definition in the Flow Name field.
4. Select one of the following format options from the Device View list:
5. Enter the port ID or WWN of the source port in the Source field or click the ellipsis button to
6. Enter the port ID or WWN of the destination port in the Destination field or click the ellipsis
7.
8. Click OK to deploy the flow definition.
1206
predefined_monitor
Sample Add Flow -
•
Port Address (port ID) — Select to display the source and destination device address using
the port ID.
•
WWN (world wide name) — Select to display the source and destination device address
using the port WWN.
select a port from the list.
Enter an asterisk (*) to use any port. To select the source port from a list, refer to
end device port from a list of available device ports"
button to select a port from the list.
Enter an asterisk (*) to use any port. To select the destination port from a list, refer to
"Selecting an end device port from a list of available device ports"
Click Show Details to view information about the Target Switch, Ingress, and Egress ports
based on the selected port.
This data is not editable. Click Hide Details to hide the Target Switch, Ingress, and Egress port
information.
The Deployment Status dialog box displays with a list of all defined flows in the Flow Definitions
Status table, as shown is
dialog box
Figure 518.
on page 1144".
on page 1144".
Brocade Network Advisor SAN User Manual
"Selecting an
53-1003154-01