Brocade Communications Systems WFT-2D User Manual page 568

12
Ports
4. Define a filter by entering a value that corresponds to the selected property in the Value
5. Repeat steps 2 through 4 as needed to define more filters.
6. Click OK.
Resetting the filter
Reset immediately clears all existing definitions. You cannot cancel the reset.
To reset the Filter dialog box, complete the following steps.
1. Click the Filter link from the Port Connectivity View dialog box.
2. Click Reset.
Enabling the filter
To enable the filter, select the Filter check box.
Disabling the filter
To disable the filter, clear the Filter check box.
516
•
==
•
!=
•
<
•
>
•
<=
•
>=
•
contains
•
matches
column.
The Port Connectivity View dialog box displays. If filtering is already enabled, only those ports
that meet the filter requirements display. To enable the filter, select the Filter check box.
The Filter dialog box displays.
All existing definitions are cleared automatically. You cannot cancel the reset.
Brocade Network Advisor SAN User Manual
53-1003154-01