Setting Pseudo Event Policies - Brocade Communications Systems WFT-2D User Manual

32
Pseudo events
2. Click Add.
3. The Identification pane of the Add Pseudo Event dialog box displays.
4. Type a unique name for the pseudo event. Duplicate names are not allowed.
5. Select the Enabled check box to enable the pseudo event or clear the check box to disable the
6. Click Next.

Setting pseudo event policies

The Policy pane of the Add Pseudo Event dialog box, shown in
escalation, resolve, and flapping policies for the pseudo event, and then specify the time duration
for each of these policies in minutes or seconds.
To create policies for a pseudo event definition, complete the following steps.
1. Click the Escalation button to create an escalation policy, and then enter the duration of time
1296
pseudo event.
The Policy pane of the Add Pseudo Event dialog box, shown in
FIGURE 562
Policy pane of the Add Pseudo Event dialog box
that the Management application waits before performing the specified action. Specify the
escalation time in minutes or seconds.
When an event occurs, an escalation policy waits for a duration of time to see if the event
remains in that state. If it does, then the specified action in the definition is performed.
Refer to "Adding a pseudo event on the escalation policy"
instructions.
Figure 562, displays.
Figure 562, allows you to create
on page 1300 for complete
Brocade Network Advisor SAN User Manual
53-1003154-01