Brocade Communications Systems WFT-2D User Manual page 780

20
Steps for connecting to an ESKM/SKM appliance
3. Enter the required information under Create Certificate Request.
4. Click Create Certificate Request.
5. Select the newly created server certificate from the Certificate List.
6. Select Properties.
7.
8. Under Certificates & CAs, select Local CAs.
9. From the CA Name column, select the name of the local CA you just created in
10. Click Sign Request.
11. Enter the required data in the Sign Certificate Request section of the window.
12. Paste the copied certificate request data into the Certificate Request box.
13. Click Sign Request.
14. Click Download to download the signed certificate to your local system.
15. Copy the signed certificate data, from
16. From the Security tab select Certificates under Certificates & CAs.
17. Select the server certificate name you just created from the certificate list, and select
18. Click Install Certificate.
19. Paste the signed certificate data you copied under Certificate Response, then click Save.
728
-
Enter a Certificate Name and Common Name. The same name may be used for both.
-
Enter your organizational information.
-
Enter the E-mail Address where you want messages to the Security Officer to go.
-
Enter the Key Size. HP recommends using the default value: 1024.
Successful completion is indicated when the new entry for the server certificate displays on the
Certificate List with a Certificate Status of Request Pending.
The pending request displays under Certificate Request Information.
Copy the certificate data from
CERTIFICATE REQUEST
--–––
the data.
The Certificate and CA Configuration page is displayed.
local Certificate Authority (CA) on ESKM/SKM"
-
Select the CA name from the Sign with Certificate Authority drop-down list.
-
Select Server as the Certificate Purpose.
-
Enter the number of days before the certificate must be renewed based on your site's
security policies. The default value is 3649 or 10 years.
The signed certificate request data displays under Sign Certificate Request.
extra carriage returns or spaces after the data.
Properties.
The Certificate Request Information window displays.
The Certificate Installation window displays.
The status of the server certificate should change from Request Pending to Active.
BEGIN CERTIFICATE REQUEST
-----
lines. Be careful to exclude extra carriage returns or spaces after
on page 726.
BEGIN to END
-----
to END
----- -----
"Setting up the
lines. Be careful to exclude
-----
Brocade Network Advisor SAN User Manual
53-1003154-01