To Another Device - Brocade Communications Systems WFT-2D User Manual

25
Saving or copying Allow/Prohibit Matrix configurations to another device
Saving an Allow/Prohibit Matrix configuration to another device
To save an existing Allow/Prohibit Matrix configuration to another device, complete the following
steps.
1. Select Configure > Allow/Prohibit Matrix.
2. Select the Allow/Prohibit Matrix configuration you want to save.
3. Click Save As.
4. Enter a name for the configuration.
5. Enter a description for the configuration.
6. Select the check box for the device to which you want to save the configuration in the Selected
7.
1030
The Configure Allow/Prohibit Matrix dialog box displays.
You can do this by expanding the view for the switch under Available Switches and selecting a
configuration, or you can select the matrix under Allow/Prohibit Matrix.
The Save As/Duplicate dialog box displays, as shown in
FIGURE 469
Save As/Duplicate dialog box
Switch list.
Click OK.
A message displays stating that the outstanding port configuration is discarded when copying
a configuration from the switch with more ports to a switch with fewer ports and vice versa.
Click OK to close the message.
The saved configuration displays in the Available Switches table under the selected switch. To
edit this configuration, refer to
"Configuring an Allow/Prohibit Matrix manually"
Figure 469
"Configuring an Allow/Prohibit Matrix"
on page 1027.
on page 1030.
on page 1025 or
Brocade Network Advisor SAN User Manual
53-1003154-01