Brocade Communications Systems WFT-2D User Manual page 934

20
Viewing and editing encryption group properties
3. Click Add.
4. Based on your selection, do one of the following:
5. Select the Encryption Mode. Options are Clear Text, DF-Compatible Encryption, and Native
882
NOTE
If groups are not visible in the Encryption Center Devices table, select View > Groups from the
menu task bar.
The Add Tape Pool dialog box displays. (Refer to
the default; however, you can change the tape pool label type to Number (Refer to
FIGURE 418
Add Tape Pool by name dialog box
FIGURE 419
Add Tape Pool by number dialog box
•
If you selected Name as the Tape Pool Label Type, enter a name for the tape pool. This
name must match the tape pool label or tape ID that is configured on the tape
backup/restore application.
•
If you selected Number as the Tape Pool Label Type, enter a (hex) number for the tape
pool. This number must match the tape pool label or tape number that is configured on
the tape backup/restore application.
Encryption. Note the following:
•
DF-Compatible Encryption is valid only when LKM/SSKM is the key vault.
•
The Key Lifespan (days) field is editable only if the tape pool is encrypted.
•
If Clear Text is selected as the encryption mode, the key lifespan is disabled.
NOTE
You cannot change the encryption mode after the tape pool I/O begins. DF-compatible
encryption requires a DF-compatible encryption license to be present on the switch. If the
license is not present, a warning message displays.
Figure 418.) The Name tape pool label type is
Brocade Network Advisor SAN User Manual
Figure 419.)
53-1003154-01