Brocade Communications Systems WFT-2D User Manual page 1294

31
Adding a configuration policy manager
6. To set configuration policy managers for fabrics, select the Fabric Checks tab and complete the
1242
•
To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the configuration policy
manager:
To configure deployment to run only once, refer to

configuration policy manager schedule"
To configure hourly deployment, refer to

manager schedule"
To configure daily deployment, refer to

manager schedule"
To configure weekly deployment, refer to

manager schedule"
To configure monthly deployment, refer to

manager schedule"
following steps.
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
•
Select the Enabled option to determine if zoning is enabled.
•
Select the Disabled option to determine if zoning is disabled.
For more information about this check and a fix for rule violations, refer to
monitors" on page 1232.
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
For more information about this check and a fix for rule violations, refer to
monitors" on page 1232.
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
For more information about this check and a fix for rule violations, refer to
monitors" on page 1232.
d. Select the Check zones that do not contain any online member check box to identify zones
in which all zone members are offline.
For more information about this check and a fix for rule violations, refer to
monitors" on page 1232.
e. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended threshold ratio is 1:1 (1 initiator port to 1 target port).
Therefore, if the ratio for the storage port is equal to or higher than 1:1, the configuration
policy manager considers it as a violation and logs it in the report.
f. Select the fabrics to which you want to apply this policy in the Available Fabrics list and
click the right arrow button.
NOTE
You can use the All Fabrics target in the Available Fabrics list for future provisioning. Select
All Fabrics and click the right arrow button to apply this policy to all discovered fabrics.
on page 1246.
"Configuring an hourly configuration policy
on page 1246.
"Configuring a daily configuration policy
on page 1246.
"Configuring a weekly configuration policy
on page 1247.
"Configuring a monthly configuration policy
on page 1247.
"Configuring a one-time
"Fabric policy
"Fabric policy
"Fabric policy
"Fabric policy
Brocade Network Advisor SAN User Manual
53-1003154-01