Deleting a Top Talker monitor
Procedures in this section pertain to deleting monitors created on systems using the legacy Top
Talkers feature and not those created with Flow Vision.
For systems using Fabric OS version 7.2 or later, when you select a device or device port, and then
select Monitor > Performance > Top Talkers, a message displays that you can use Flow Vision to
provide Top Talkers monitoring. You have these options:
•
•
To delete Top Talker monitors, use the following steps:
1. Select the dialog box of the Top Talker monitor you want to delete.
2. Click Close.
3. Click Yes on the "Do you want to delete this monitor?" message.
Pausing a Top Talker monitor
Procedures in this section pertain to pausing monitors created on systems using the legacy Top
Talkers feature and not those created with Flow Vision.
For systems using Fabric OS version 7.2 or later, when you select a device or device port, and then
select Monitor > Performance > Top Talkers, a message displays that you can use Flow Vision to
provide Top Talkers monitoring. You have these options:
•
Brocade Network Advisor SAN User Manual
53-1003154-01
The top 20 conversations display in the Current Top Talkers list. The Top Talkers Summary list
displays all Top Talkers that occurred since the Top Talker Selector dialog box was opened
(displays a maximum of 360). When the maximum is reached, the oldest Top Talker drops as a
new one occurs.
The F_Port mode Top Talker provides the following details:
•
Rx Ave (MB/sec) or Tx Ave (MB/sec)
•
Occurrences
•
Source
•
Source Switch/Port
•
Destination
•
Destination Switch/Port
•
% Utilization
To use Flow Vision, delete existing monitors, then use the Add Flow Definition dialog box to
define an initiator and target port pair for monitoring. Refer to
more information.
Clicking OK opens the legacy Top Talkers dialog box. To use the legacy Top Talkers feature, you
must deactivate existing flows defined for the switch for Flow Vision.
Refer to steps 1-5 under
"Configuring a fabric mode Top Talker monitor"
"Configuring an F_Port mode Top Talker monitor"
To use Flow Vision, delete existing monitors, then use the Add Flow Definition dialog box to
define an initiator and target port pair for monitoring. Refer to
more information.
SAN Top Talker monitoring
•
Last Occurred
•
SID
•
Source Port
•
DID
•
Destination Port
•
Port Speed
Chapter 29, "Flow Vision"
on page 1096 or
on page 1098 to display this dialog box.
Chapter 29, "Flow Vision"
28
for
for
1099