21
Traffic Isolation zones
Disabling a Traffic Isolation zone
NOTE
Traffic Isolation zones are configurable only on a Fabric OS device.
Traffic Isolation zones are enabled by default when you create them. Use this procedure to disable
a Traffic Isolation zone. To apply the settings and deactivate the zone, you must activate a zone
configuration in the same zone database.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
4. Right-click the Traffic Isolation zone you want to disable in the Zones list and clear the
5. Click OK or Apply to save your changes.
Enabling failover on a Traffic Isolation zone
NOTE
Traffic Isolation zones are configurable only on a Fabric OS device.
1. Select Configure > Zoning > Fabric.
2. Click the Zone DB tab if that tab is not automatically displayed.
3. Select a fabric from the Zoning Scope list.
4. Right-click the Traffic Isolation zone upon which you want to enable failover in the Zones list
5. Click OK or Apply to save your changes.
Disabling failover on a Traffic Isolation zone
NOTE
Traffic Isolation zones are configurable only on a Fabric OS device.
If failover is disabled, be aware of the following considerations:
•
920
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
Configured Enabled check box.
The Traffic Isolation zone is not disabled until you activate a zone configuration in the same
zone database.
The Zoning dialog box displays.
This identifies the target entity for all subsequent zoning actions and displays the zoning
database for the selected entity.
and select Configured Failover.
Ensure that there are non-dedicated paths through the fabric for all devices that are not in a TI
zone.
Brocade Network Advisor SAN User Manual
53-1003154-01