Adding An Snmp V3 Credential - Brocade Communications Systems WFT-2D User Manual

TABLE 106
SNMP
credential type
v1
v2c
v3
v3
v3
For information about how to configure SNMP credentials, refer to
on page 1269 or

Adding an SNMP v3 credential

The SNMP v3 Credentials dialog box allows you to add the SNMP v3 credentials.
To add an SNMP v3 credential, complete the following steps.
1. Select Monitor > SNMP Setup > Event Reception.
2. Select an SNMP v3 credential from the SNMP v3 Credentials list on the Event Reception dialog
3. Click Add.
4. Type the user name in the User Name field.
Brocade Network Advisor SAN User Manual
53-1003154-01
SNMP security and authentication
Privacy protocol
No authentication
No privacy protocol
No authentication
No privacy protocol
No authentication
No privacy protocol
Authentication
No privacy protocol
Authentication
Privacy protocol
"Adding an SNMP v1 or v2c community string"
The Event Reception dialog box displays.
box.
The Add SNMP v3 Credentials dialog box, shown in
FIGURE 543
Add SNMP v3 Credentials dialog box
For configurations that do not have authentication or privacy, the Management application
uses the user name to match for authentication.
Authentication Result
Community string Uses a community string to match for authentication.
Community string Uses a community string to match for authentication.
User name Uses a user name to match for authentication.
MD5 or SHA Provides authentication based on the HMAC-MD5
(Message Digest Algorithm) or HMAC-SHA algorithms
(Secure Hash Algorithm).
MD5 or SHA Provides authentication based on the HMAC-MD or
HMAC-SHA algorithms (Hash-based Message
Authentication).
Provides privacy based on CBC_DES (Cipher Block
Chaining) or CFB_AES_128 (Cipher Feedback).
Figure
SNMP traps
"Adding an SNMP v3 credential"
on page 1270.
543, displays.
32
1269