3. Select Fabric in the Top Talker Mode list to select a switch to monitor.
4. Select an available switch from a fabric in the left panel, and then the right arrow to move it to
5. Click OK on the Top Talker Selector dialog box.
6. Select the number of Top Talkers (1 through 20) to display from the Display list.
7.
8. Click Apply.
8. Click Destination to launch the Port Properties dialog box for the Destination port.
9. Click Source to launch the Port Properties dialog box for the Source port.
Brocade Network Advisor SAN User Manual
53-1003154-01
FIGURE 481
Top Talker Selector dialog box
the right panel.
You can select only one device on which to enable Top Talkers.
Top Talkers is enabled on the selected device. The Top Talkers - Fabric Mode for Device_Name
dialog box displays.
Select how often you want the Top Talker to refresh (10, 20, 30, 40, or 50 seconds, or 1
minute) from the Refresh Interval list.
The top 20 conversations display in the Current Top Talkers list. The Top Talkers Summary list
displays all Top Talkers that occurred since the Top Talkers - Fabric Mode for Device_Name
dialog box was opened (displays a maximum of 360). When the maximum is reached, the
oldest Top Talker drops as a new one occurs.
The fabric mode Top Talker provides the following details:
•
Tx+Rx Ave (MB/sec)
•
Occurrences
•
Source
•
Source Switch/Port
•
Destination
•
Destination Switch/Port
SAN Top Talker monitoring
•
Last Occurred
•
SID
•
Source Port
•
DID
•
Destination Port
28
1097