Brocade Communications Systems WFT-2D User Manual page 663

3. Click the DCB tab.
4. Click the VLAN tab.
5. Click Add.
6. Enter the VLAN identifier in the VLAN ID field.
7.
8. Select the VLAN you created and click Edit to convert the VLAN to FCoE VLAN.
9. Select the FCoE check box.
10. Select the DCB interface to carry the FCoE traffic from the Selection List and click Add to add it
11. Click OK on the VLAN Configuration dialog box to save your changes.
12. Close the Web Tools application.
Creating and activating VLAN classifiers on the DCB interface
NOTE
You can complete this procedure using the Management application for Fabric OS versions 7.0 and
later. For Fabric OS versions earlier than Fabric OS 7.0, you must use the CLI.
To create and activate the VLAN classifiers on the DCB interface, complete the following steps.
1. Log in to the switch and enter global configuration mode.
2. Create and apply VLAN classifiers to the DCB interface to classify Ethernet frames on an
3. Apply the VLAN classifier group to the DCB interface.
4. Save the running-config file to the startup-config file.
Brocade Network Advisor SAN User Manual
53-1003154-01
The Web Tools application displays. You can also launch Web Tools by clicking the Element
Manager button on the DCB Configuration dialog box.
The VLAN Configuration dialog box displays.
Click OK on the VLAN Configuration dialog box.
to the Selected List.
switch:<userid>>cmsh
switch#configure terminal
untagged interface to VLAN.
switch(config)#vlan classifier rule 1 proto fip encap ethv2
switch(config)#vlan classifier rule 2 proto fcoe encap ethv2
switch(config)#vlan classifier group 1 add rule 1
switch(config)#vlan classifier group 1 add rule 2
switch(conf-if-te-0/7)#vlan classifier activate group 1 vlan 1002
switch#copy running-config startup-config
16
DCB configuration
611