Garp Commands; Set Garp Timer Join - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

8.1 GARP Commands

This section describes the commands you use to configure GARP and view GARP status.
The commands in this section affect both GVMP and GMRP.

8.1.1 set garp timer join

This command sets the GVRP join time for one or all ports and per GARP. Join time is the
interval between the transmission of GARP Protocol Data Units (PDUs) registering (or re-
registering) membership for a VLAN or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds). The value 20 centiseconds is 0.2 seconds.
Default
Format
Modes
8.1.1.1 no set garp timer join
This command sets the GVRP join time (for one or all ports and per GARP) to the default.
Note: This command has an effect only when GVRP is enabled.
Format
Modes
8-2
20
set garp timer join <10-100>
Interface Config
Global Config
no set garp timer join
Interface Config
Global Config
v1.0, December 2005
GARP, GVRP, and GMRP Commands