Logging Console; Logging Host - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
18.3.2.1 no logging wrap
This command disables wrapping of in-memory logging and configures logging to stop
when the log file capacity is full.
Format
Mode

18.3.3 logging console

This command enables logging to the console. You can specify the
value as either an integer from 0 to 7 or symbolically through one of the following
keywords:
emergency
informational
Default
Format
Mode
18.3.3.1 no logging console
This command disables logging to the console.
Format
Mode

18.3.4 logging host

This command enables logging to a host. You can configure up to eight hosts. The
is the IP address of the logging host. The
<ipaddr>
to 65535. You can specify the
symbolically through one of the following keywords:
(2), (3),
error
Default
Format
Mode
18-22
no logging buffered wrap
Privileged EXEC
(0), (1),
alert
(6), or (7).
debug
disabled; critical
logging console [severitylevel]
Global Config
no logging console
Global Config
<severitylevel>
(4), (5),
warning notice
port - 514; level - critical;
logging host <ipaddr> [<port>][<severitylevel>]
Global Config
v1.0, December 2005
(2), (3),
critical error
<port>
value as either an integer from 0 to 7 or
emergency
(6), or
informational
System Maintenance Commands
<severitylevel>
(4),
warning notice
value is a port number from 1
(0), (1),
alert critical
(7).
debug
(5),