Configure Auto-Voip; Configure Protocol-Based Port Settings - NETGEAR GC728X User Manual

Insight Managed 28-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP 1G & 2 SFP+ 10G Fiber Ports
• VLAN ID. Configure the phone to send tagged voice traffic. With this selection, you
can enter a Dot1p value in the Value field.
• Dot1p. Configure voice VLAN 802.1p priority tagging for voice traffic. With this
selection, you must enter a dot1p value in the Value field.
• Untagged. Configure the phone to send untagged voice traffic.
9. In the Value field, enter the VLAN ID or dot1p value.
This field is enabled only when VLAN ID or dot1p is selected as the interface mode.
10. In the CoS Override Mode field, select Disable or Enable.
The default is Disable.
11. In the Authentication Mode field, select Enable or Disable.
The default is Enable. When the authentication mode is enabled, voice traffic is allowed
on an unauthorized voice VLAN port. When the authentication mode is disabled, devices
are authorized through dot1x.
Note: Authentication through dot1x is possible only if dot1x is enabled.
12. In the DSCP Value field, configure the Voice VLAN DSCP value for the port.
The valid range is 0 to 64. The default value is 0.
The Operational State field displays the operational status of the voice VLAN on the
interface.
13. Click the Apply button.
Your settings are saved.

Configure Auto-VoIP

Voice over Internet Protocol (VoIP) enables telephone calls over a data network. Because
voice traffic is typically more time-sensitive than data traffic, the Auto-VoIP feature helps
provide a classification mechanism for voice packets so that they can be prioritized above
data packets in order to provide better Quality of Service (QoS). With the Auto-VoIP feature,
voice prioritization is provided based on call-control protocols (SIP, SCCP, H.323) or OUI bits.

Configure Protocol-Based Port Settings

To prioritize time-sensitive voice traffic over data traffic, protocol-based Auto-VoIP checks for
packets carrying the following VoIP protocols:
• Session Initiation Protocol (SIP)
• H.323
• Signalling Connection Control Part (SCCP)
Configure Switching
128