Ipv6 Access-List Rename; Deny | Permit} (Ipv) - NETGEAR GSM7228PS Cli Manual

If an IPv6 ACL by this name already exists, this command enters IPv6-Access-List config mode to
allow updating the existing IPv6 ACL.
Note: The CLI mode changes to IPv6-Access-List Config mode when you successfully
execute this command.
Format
ipv6 access-list <name>
Mode Global Config
no ipv6 access-list
This command deletes the IPv6 ACL identified by <name> from the system.
Format
no ipv6 access-list <name>
Mode Global Config

ipv6 access-list rename

This command changes the name of an IPv6 ACL. The <name> parameter is the name of an
existing IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1 to
31 characters uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
Format
ipv6 access-list rename <name> <newname>
Mode Global Config
{deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to the list
of configured rules for the list.
Note: The 'no' form of this command is not supported, since the rules within an IPv6
ACL cannot be deleted individually. Rather, the entire IPv6 ACL must be deleted
and respecified.
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
8-45