Show Classofservice Dot1P-Mapping - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a whole.
Also known as rate shaping, traffic shaping has the effect of smoothing temporary traffic bursts
over time so that the transmitted traffic rate is bounded.
Format
traffic-shape <bw>
Modes • Global Config
• Interface Config
no traffic-shape
This command restores the interface shaping rate to the default value.
Format
no traffic-shape
Modes • Global Config
• Interface Config

show classofservice dot1p-mapping

This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The <unit/slot/port> parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the 802.1p
mapping table of the interface is displayed. If omitted, the most recent global configuration
settings are displayed. For more information, see
Format
show classofservice dot1p-mapping [<unit/slot/port>]
Mode Privileged EXEC
The following information is repeated for each user priority.
Term Definition
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority value is mapped.
Quality of Service (QoS) Commands
Managed Switch CLI Manual, Release 8.0
"Voice VLAN Commands" on page 3-48
v1.0, July 2009
.
8-5