Set Up The Lacp System Priority For The Switch; Set Up Lacp Port Priority And Time-Out Values - NETGEAR GS110 User Manual

8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS110EMX
e. Click the Apply button.
Your settings are saved.

Set Up the LACP System Priority for the Switch

The LACP system priority specifies the link aggregation priority of the switch relative to
the devices at the other ends of the links on which link aggregation is enabled. The
default is 32768. A higher value indicates a lower priority. The value of the priority
applies to all LACP LAGs that you set up on the switch.
To change the LACP system priority:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired network connection, or connect directly to a switch that
is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
4. Enter the switch password.
The default password is password. The password is case-sensitive.
The Switch Information page displays.
5. Select System > LAG > LACP Configuration.
The LACP Configuration page displays.
6. In the LACP System Priority field, enter a number from 1 to 65535.
The default is 32768.
7. Click the Apply button.
Your settings are saved.

Set Up LACP Port Priority and Time-Out Values

You can set the LACP port priority value and LACP time-out value for a port. By default,
the LACP port priority value for a port is 128 and the time-out value is Long.
Manage Network Settings 59 User Manual