Show Ip Ospf Range - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

14.6.48 show ip ospf range

This command displays information about the area ranges for the specified <
< > identifies the OSPF area whose ranges are being displayed.
areaid
Format
Modes
Area ID
IP Address
Subnet Mask
Lsdb Type
Routing Commands
Down- initial state of the neighbor conversation - no recent
information has been received from the neighbor.
Attempt - no recent information has been received from the
neighbor but a more concerted effort should be made to con-
tact the neighbor.
Init - an Hello packet has recently been seen from the neigh-
bor, but bi-directional communication has not yet been estab-
lished.
2 way - communication between the two routers is bi-direc-
tional.
Exchange start - the first step in creating an adjacency
between the two neighboring routers, the goal is to decide
which router is the master and to decide upon the initial DD
sequence number.
Exchange - the router is describing its entire link state data-
base by sending Database Description packets to the neigh-
bor.
Loading - Link State Request packets are sent to the neighbor
asking for the more recent LSAs that have been discovered
(but not yet received) in the Exchange state.
Full - the neighboring routers are fully adjacent and they will
now appear in router-LSAs and network-LSAs.
show ip ospf range <areaid>
Privileged EXEC
User EXEC
The area id of the requested OSPF area.
An IP Address which represents this area range.
A valid subnet mask for this area range.
The type of link advertisement associated with this area
range.
v1.0, December 2005
>. The
areaid
14-55