Ip Pimsm Rp-Candidate; Ip Pimsm Spt-Threshold - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

ip pimsm rp-candidate

This command is used to configure the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Default None
Format
ip pimsm rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode Global Config
no ip pimsm rp-candidate
This command is used to disable the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR).
Format
no ip pimsm rp-candidate interface <unit/slot/port> <group-address>
<group-mask>
Mode Global Config

ip pimsm spt-threshold

This command is used to configure the Data Threshold rate for the last-hop router to switch to the
shortest path. The rate is specified in Kilobits per second. The possible values are 0 to 2000.
Default 0
Format
ip pimsm spt-threshold <0-2000>
Mode Global Config
no ip pimsm spt-threshold
This command is used to set the Data Threshold rate for the RP router to the default value.
Format
no ip pimsm spt-threshold
Mode Global Config
IP Multicast Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
5-21