Router Discovery Protocol Commands; Ip Irdp; Ip Irdp Multicast - NETGEAR ProSAFE M7100-24X Reference Manual

ProSAFE M7100 Managed Switches
Parameter
Memory Available in
Heap
In Use High Water
Mark
The following shows example CLI display output for the command.
(netgear switch) #show routing heap summary
Heap Size....................... 92594000 bytes
Memory In Use................... 149598 bytes (0%)
Memory on Free List............. 78721 bytes (0%)
Memory Available in Heap........ 92365249 bytes (99%)
In Use High Water Mark.......... 210788 bytes (0%)

Router Discovery Protocol Commands

This section describes the commands you use to view and configure Router Discovery Protocol
settings on the switch. The Router Discovery Protocol enables a host to discover the IP address
of routers on the subnet.

ip irdp

This command enables Router Discovery on an interface.
Default disabled
Format
ip irdp
Mode Interface Config
no ip irdp
This command disables Router Discovery on an interface.
Format
no ip irdp
Mode Interface Config

ip irdp multicast

This command configures the address that the interface uses to send the router discovery
advertisements. The address is 224.0.0.1, which is the all-hosts IP multicast address.
Default 224.0.0.1
Format
ip irdp multicast
Mode Interface Config
Description
The number of bytes in the original heap that have never been allocated.
The maximum memory in use since the system last rebooted.
Routing Commands
195