Routing Information Protocol (Rip) Commands; Router Rip; Enable (Rip); Ip Rip - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

14.6 Routing Information Protocol (RIP) Commands

This section describes the commands you use to view and configure RIP, which is a
distance-vector routing protocol that you use to route traffic within a small network.

14.6.1 router rip

Use this command to enter Router RIP mode.
Format
Mode

14.6.2 enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
Default
Format
Mode
14.6.2.1 no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format
Mode

14.6.3 ip rip

This command enables RIP on a router interface.
Default
Format
Mode
14.6.3.1 no ip rip
This command disables RIP on a router interface.
Format
Mode
14-54
router rip
Global Config
enabled
enable
Router RIP Config
no enable
Router RIP Config
disabled
ip rip
Interface Config
no ip rip
Interface Config
v1.0, October 2008
Routing Commands