Ip Ospf Transmit-Delay; Ip Ospf Mtu-Ignore - NETGEAR M6100 Series Reference Manual

ip ospf transmit-delay

This command sets the OSPF Transit Delay for the specified interface or range of interfaces.
The transmit delay is specified in seconds. In addition, it sets the estimated number of
seconds it takes to transmit a link state update packet over this interface. The value for
second ranges from 0 to 3600 (1 hour).
Default 1
Format
ip ospf transmit-delay second
Mode Interface Config
no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
Format
no ip ospf transmit-delay
Mode Interface Config

ip ospf mtu-ignore

This command disables OSPF maximum transmission unit (MTU) mismatch detection on an
interface or range of interfaces. OSPF Database Description packets specify the size of the
largest IP packet that can be sent without fragmentation on the interface. When a router
receives a Database Description packet, it examines the MTU advertised by the neighbor. By
default, if the MTU is larger than the router can accept, the Database Description packet is
rejected and the OSPF adjacency is not established.
Default enabled
Format
ip ospf mtu-ignore
Mode Interface Config
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format
no ip ospf mtu-ignore
Mode Interface Config
M6100 Series Switches
Routing Commands
728