Term
Definition
Mode
Indicates whether the virtual router is enabled or disabled.
State
The state (Master/backup) of the virtual router.
DHCP and BOOTP Relay Commands
This section describes the commands you use to configure BootP/DHCP Relay on the
switch. A DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies
between clients and servers when they are not on the same physical subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default
disabled
Format
bootpdhcprelay cidoptmode
Mode
Global Config
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay cidoptmode
Mode
Global Config
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay
on the system. The <hops> parameter has a range of 1 to 16.
Default
4
Format
bootpdhcprelay maxhopcount <1-16>
Mode
Global Config
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP
Relay on the system.
Format
no bootpdhcprelay maxhopcount
Mode
Global Config
ProSafe Managed Switch
Routing Commands
263