Ip Routing Commands - NETGEAR GSM7228PS Cli Manual

Term Definition
IP Address The IP address of a device on a subnet attached to the switch.
MAC Address The hardware MAC address of that device.
Interface The routing unit/slot/port associated with the device's ARP entry.

IP Routing Commands

This section describes the commands you use to enable and configure IP routing on the switch.
routing
This command enables IPv4 and IPv6 routing for an interface. You can view the current value for
this function with the show ip brief command. The value is labeled as "Routing Mode."
Default disabled
Format
routing
Mode Interface Config
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The value
is labeled as "Routing Mode."
Format
no routing
Mode Interface Config
ip routing
This command enables the IP Router Admin Mode for the master switch.
Format
ip routing
Mode Global Config
Routing Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
4-8