Ip Routing Commands; Routing; Section 14.2 "Ip Routing Commands - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,
Dynamic Renew
Mode
Total Entry Count
Current / Peak
Static Entry Count
Current / Max

14.2 IP Routing Commands

This section describes the commands you use to enable and configure IP routing on the
switch.

14.2.1 routing

This command enables routing for an interface.
You can view the current value for this function with the
labeled as "Routing Mode."
Default
Format
Mode
14.2.1.1 no routing
This command disables routing for an interface.
You can view the current value for this function with the
labeled as "Routing Mode."
Format
Mode
Routing Commands
Displays whether the ARP component automatically attempts
to renew dynamic ARP entries when they age out.
Field listing the total entries in the ARP table and the peak
entry count in the ARP table.
Field listing the static entry count in the ARP table and maxi-
mum static entry count in the ARP table.
disabled
routing
Interface Config
no routing
Interface Config
v3.0, January 2008
command. The value is
show ip
command. The value is
show ip
14-7