Storm-Control Unicast Rate; Show Storm-Control - NETGEAR M6100 Series Reference Manual

no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode) and disables unicast
storm recovery.
Format
no storm-control unicast level
Mode Global Config
Interface Config

storm-control unicast rate

Use this command to configure the unicast storm recovery threshold for all interfaces (Global
Config mode) or one or more interfaces (Interface Config mode) in packets per second. If the
mode is enabled, unicast storm recovery is active, and if the rate of L2 broadcast traffic
ingressing on an interface increases beyond the configured threshold, the traffic is dropped.
Therefore, the rate of unicast traffic is limited to the configured threshold. The threshold rate
can be in the range from 0–33554431. The default is 0.
Default 0
Format
storm-control unicast rate threshold
Mode Global Config
Interface Config
no storm-control unicast rate
This command sets the unicast storm recovery threshold to the default value for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode) and disables unicast
storm recovery.
Format
no storm-control unicast rate
Mode Global Config
Interface Config

show storm-control

This command displays switch configuration information. If you do not use any of the optional
parameters, this command displays global storm control configuration parameters:
• Broadcast Storm Recovery Mode may be enabled or disabled. The factory default is
disabled.
• 802.3x Flow Control Mode may be enabled or disabled. The factory default is disabled.
M6100 Series Switches
Switching Commands
425