Table 35: Tx Matrix And Tx Matrix Plus Router Chassis Component Alarm - Juniper M Series Monitoring And Troubleshooting Manual

M Series and T Series Routers Monitoring and Troubleshooting Guide
108

Table 35: TX Matrix and TX Matrix Plus Router Chassis Component Alarm

Conditions
Chassis
Component Alarm Condition
Air filter Change the air filter.
Alternative media The router boots from
alternate boot device, the
hard disk. Typically, the router
boots from the flash drive. If
you configure your router to
boot from the hard disk, ignore
this alarm condition.
Control Board A Control Board was removed.
A Control Board temperature
sensor alarm has failed.
A Control Board failed.
CIP A CIP is missing.
Craft interface The craft interface failed.
Fan trays One fan tray was removed
from the chassis.
Two or more fan trays were
removed from the chassis.
One fan in the chassis is not
spinning or is spinning below
the required speed.
Alarm
Remedy Severity
Change the air filter. ------------------------
For technical support, Yellow
open a support case
using the Case Manager
link at
http://www.juniper.net
/support/
or call
1-888-314-JTAC (within
the United States) or
1-408-745-9500
(outside the United
States).
Insert a Control Board Yellow
into an empty slot.
Replace the failed Yellow
Control Board.
Replace the failed Red
Control Board.
Insert a CIP into an Red
empty slot.
Replace the failed craft Red
interface.
Install the missing fan Yellow
tray.
Install the missing fan Red
trays.
Replace the fan tray. Red
Copyright © 2012, Juniper Networks, Inc.