Parameter List - Mitsubishi Electric 800 Series Instruction Manual

3.4

Parameter list

The following parameters are used for the plug-in option (FR-A8AX).
The FR-A8AX does not function with the initial setting. When a value other than "9999" is set in Pr.304, digital input is enabled.
Set the following parameters according to applications.
Pr. Pr. group
*1 *1
BCD input bias
300 D600
*1 *1
BCD input gain
301 D601
*1 *1
BIN input bias
302 D602
*1 *1
BIN input gain
303 D603
Digital input and analog input
*1 *1
compensation enable/disable
304 D604
selection
*1 *1
Read timing operation selection
305 D605
*1*2 *1*2
Digital input unit selection
329 D606
*1*5 *1*5
Digital torque command bias
447 D620
*1*5 *1*5
Digital torque command gain
448 D621
*5 *5
Torque command source selection
804 D400
*1 Parameters which can be displayed when the plug-in option (FR-A8AX) is mounted.
*2 For Pr.329, write is disabled during operation even when "2" is set in Pr.77. To change the parameter setting value, stop the operation.
Also, parameter clear is invalid.
*3 The initial values differ for the FM type and CA type of the inverter.
*4 The setting range of Pr. 304 differs according to the inverter used. (Refer to
*5 These parameters can be set for the FR-A800 series only.
Name
0 to 590 Hz
0 to 590 Hz, 9999
0 to 590 Hz
0 to 590 Hz, 9999
0 to 4, 10 to 14, 9999
0, 1, 10
0, 1, 2, 3
0 to 400%
0 to 400%, 9999
0, 1, 3 to 6
Minimum
Setting range setting
increments
0.01 Hz
0.01 Hz
0.01 Hz
0.01 Hz
*4
1
1
1
1%
1%
1
page 24)
16-BIT DIGITAL INPUT
Initial Refer to
value page
0 Hz 28
*3
28
60/50 Hz
0 Hz 28
*3
28
60/50 Hz
3
9999 24, 25, 31
0 25
1 29
0 31
150% 31
0 31
23