Honda Accord 2008 Manual page 1797

07/11/02 09:38:23 61TA0000_200_0230
Seats
Trunk Pass-through Lid Lock Cylinder Replacement
Special Tools Required
KTC trim tool set SOJATP2014
Available through the American Honda Tool and
Equipment Program; call 888-424-6857
4-door
NOTE:
• Take care not to scratch the trunk pass-through lid.
• Use the appropriate tool from the KTC trim tool set to
avoid damage when removing components.
1. Using the appropriate trim tool, pry the handle (A)
up at both hook portions (B) on the forward side of
the trunk pass-through lid (C). Then slide the
handle half-way up.
＊０１
20-228
C
A
B
2. Remove the handle (A) from the trunk pass-through
lid (B) by sliding it up.
B
3. Remove the retainer clip (A), then remove the trunk
pass-through lid lock cylinder (B) from the handle
(C).
B
C
4. Install the lock cylinder in the reverse order of
removal, and note these items:
• Install the retainer clip on the handle, then install
the lock cylinder. Be sure the clip is fully seated
in the slot on the lock cylinder.
• Make sure the trunk pass-through lid opens
properly and locks securely.
ＴＡ０８ＡＢ４Ｊ４６１６６４６０４６１ＫＢＡＴ００
＊０２
A
＊０３
A