Subaru Legacy 2005 Service Manual page 3411

8. Pipe Assembly [RHD Model]
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and then remove the front
crossmember support plate and jack-up plate.
• Large type
(1) Front crossmember support plate
• Small type
(1)
(1) Front crossmember support plate
(2) Jack-up plate
• Small type (6MT model)
(2)
(1)
(1) Front crossmember support plate
(2) Jack-up plate
Pipe Assembly [RHD Model]
(1)
PS-00445
(1)
(2)
FS-00105
(1)
FS-00186
POWER ASSISTED SYSTEM (POWER STEERING)
3) Remove one pipe joint at the center of gearbox,
and connect the vinyl hose to the pipe and the joint.
Discharge the fluid by turning steering wheel fully
clockwise and counterclockwise. Discharge the flu-
id similarly from other pipes.
(1) Pipe A
(2) Pipe B
4) Remove the clamp E from the return hose and
pressure hose.
(1) Return hose
(2) Pressure hose
(3) Clamp E
PS-73
(1)
(2)
PS-00446
(2)
(3)
PS-00542
(1)